Remember these shorts that I made the other day? Want to make a pair? I bet you can do it in 3 hours today!
Below you’ll find the step by step tutorial. If you just want the pattern, just dowload the PDF here and print them normally on your printer. Connect them following the red, green and blue arrows. Keep in mind that the pattern is a size S and don’t forget to leave 2 cm sewing allowance.
Sorry for the low quality scan!
I strongly advise you to make a muslin first. You will see the fit and be able to correct it this way.
About the tutorial, if you never made a pair of shorts before, this is a good start. It’s not even necessary that you use my pattern. You can make your own pattern by using a pair of shorts that fit you loosely.
Last, but not least, if you fail, just have a drink and start again. And have fun!
First, cut your pattern, cut two backs (A in the pattern, drawn in red), 2 fronts (B and in blue in the pattern). When you cut, fold your fabric in two, good sides together and then cut. This will make it less likely that you end up with two left fronts 🙂
Now, measure your waist and divide it by four. Let’s say your waist is 66 cm/ 26 inches; cut two pieces of wide elastic of 16.5 cm/ 6.5 inches.
Cut four pieces of fabric with the same 1/4 of your waist length +2 cm sewing allowance on each side.
Now for the pleats, take the fabric from the first black arrow on the left and touch the marked spot. Pin. Do the same with the next arrow. The yellow arrow shows you how the pleat should look like after you’ve done this.
Over that pin the interior of the pocket or C2 – the brown line – in the pattern. Sew.
This is what you should have at this point. You can topstitch the edge of the pocket if you want.
Now, after you’ve turned the fabric rectangles into 2 tubes, insert the elastic into the tubes and pin. Before sewing, tuck inside the margins of the tubes.
Do this with both sides of the elastic. You should end up with a circular waist strap.
Now back to your pocket. On top of the back of what you just sewed, pin the hip part of your pants (or C1 in your pattern).
Note! In the picture it says A but, it should be B in your pattern, sorry!
Let’s check if this is what you have. Do we have pockets? : )
Now sew the center seam of your front.
It should look something like this.
And now sew the center seam of your back pieces.
If your shorts look like this, you’re on the good track.
Now, on top of that, good side down, place the backside of your shorts and sew the outside seams. Like this.
Now pin your waist strap to the edge of the pants.
Then iron the leg openings, fold once inside and one more time and sew.
You’re done! Go out and celebrate!
Hope you liked the tutorial. If you have suggestions of how it could be improved, or questions you know where to find me.
Oh, and Happy New Year!